[OpenWrt-Devel] [PATCH] lantiq: remove read-only flag on two partitions on BTHOMEHUBV3A

[Ben Mulvihill]

Remove read-only flag on two partitions on BTHOMEHUBV3A:
  uboot-config - otherwise fw_setenv command cannot be used.
  ath9k-cal    - so that ath9k calibration data can be copied
                 to the partition on a newly installed board.
 
Signed-off-by: Ben Mulvihill <ben.mulvihill at gmail.com>
---
--- a/target/linux/lantiq/dts/BTHOMEHUBV3A.dts	2016-04-24 17:30:44.117072962 +0200
+++ b/target/linux/lantiq/dts/BTHOMEHUBV3A.dts	2016-04-24 17:30:08.483732762 +0200
@@ -61,12 +61,10 @@
 				partition at 64000 {
 					label = "uboot-config";
 					reg = <0x64000 0x004000>;
-					read-only;
 				};
 				ath9k_cal: partition at 68000 {
 					label = "art-copy";
 					reg = <0x68000 0x004000>;
-					read-only;
 				};
 				partition at 6c000 {
 					label = "kernel";
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel