[OpenWrt-Devel] [PATCH 6/6] bcm53xx: R8000 handle PEX8603 switch

[Hauke Mehrtens]

On 08/15/2015 05:05 AM, Ian Kent wrote:
> On Sat, 2015-08-15 at 09:55 +0800, Ian Kent wrote:
>> On Fri, 2015-08-14 at 19:55 +0200, Hauke Mehrtens wrote:
>>> On 08/14/2015 06:03 AM, Ian Kent wrote:
>>>> On Wed, 2015-08-12 at 22:01 +0200, Hauke Mehrtens wrote:
>>>>> On 07/15/2015 12:11 PM, Ian Kent wrote:
>>>>>> On Tue, 2015-07-14 at 18:19 +0200, Rafał Miłecki wrote:
>>>>>>> On 28 June 2015 at 05:37, Ian Kent <raven at themaw.net> wrote:
>>>>>>>> Let me rework this using the bus number as you recommend.
>>>>>>>> I'll repost my updated patch series once I've done that.
>>>>>>>
>>>>>>> Hi Ian,
>>>>>>>
>>>>>>> Is there any chance you'll find a moment for it anytime soon? It'd be
>>>>>>> awesome to get R8000 support for CC release.
>>>>>>
>>>>>> I have reworked the patch and a broken package build problem I had is
>>>>>> gone but I didn't get time to fix build problems with a third patch I
>>>>>> have.
>>>>>>
>>>>>> Just didn't get time last weekend and this week has been quite busy too.
>>>>>> I'll try and get onto this in the next few days.
>>>>>>
>>>>>> Ian
>>>>>
>>>>> Hi Ian,
>>>>>
>>>>> you patch looks better than the hack Broadcom did in their vendor driver.
>>>>
>>>> I thought so, ;)
>>>>
>>>>>
>>>>> Could you send me a lspci output or the content of /proc/bus/pci/devices
>>>>> of the original firmware or of OpenWrt with your patch applied? I would
>>>>> prefer lspci because it is easier to read but cat from
>>>>> /proc/bus/pci/devices also works. I do not have such a device and want
>>>>> to understand how this PCIe switch looks like on the software side, so
>>>>> we can fix the domain, bus, slot, function mixup.
>>>>
>>>> I haven't been able to build OpenWrt for a while now and that's why I
>>>> haven't been able to test my changes to the patch.
>>>
>>> I haven't noticed a problem in the OpenWrt build system, do you still
>>> have this problem? Have you tried to clean and rebuild again?
>>
>> The problem I have now is with mkimage.
>>
>> It started after a distclean and reconfigure to ensure I was getting a
>> fully up to date repo.
> 
> OK, I had a quick look around for this problem and, much to my surprise,
> I found this (I hadn't found anything previously).
> 
> https://dev.openwrt.org/ticket/20134#comment:10
> 
> I'll try reverting the commit and see if I can make some progress over
> the weekend.
> 
> Ian
> 

I hopefully fixed the problem reported in that ticket, I am able to
build on CentOS 7 without problems. If the problem still exists for you
could you please send me the error message you get.

Hauke
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel