[PATCH 2/3] base-files: failsafe: Start also CPU interface for DSA

[Hauke Mehrtens]

On 6/20/21 4:30 PM, Sven Roederer wrote:
> Am Samstag, 19. Juni 2021, 20:36:10 CEST schrieb Hauke Mehrtens:
>> On a DSA switch the ports have an upper device, the CPU device, e.g.
>> eth0. This device has to be in up state to bring up the lower devices
>> like lan1.
>>
>> Parse the link device from "ip link show" and bring it into up stated
>> before bringing up the actual interface.
>>
>> This is needed to make network in failsafe on systems with DSA work.
>>
> 
> Hauke,
> 
> I tested you patches on the Mikrotik RB750Gr3 and WDR3600 (as I did in
> FS#3866), this time with customized IP-adresses and patches applied to
> OpenWrt-21.02.
> For the WDR3600 the issue was fixed, but for the RB750 there is no network.
> I was not able to usr IPv6 link-local, OpenWrt default 192.168.1.1 or my
> custom IP-Address.
> 
> The Rb750 is DSA, so it seems there is still something wrong. I'll retest with
> current master soon, to rule out issues based on 21.02-rc3.
> 
> Sven

Hi,

I tried it on a lantiq device with the DSA patches applied and it works 
fine.

Could you please share the content of this file: /tmp/board.json
and the output of "ip addr" while in failsafe on a broken device please.

You need all 3 patches and I am not aware of a difference between master 
and 21.02 in this area, but I only tried it on top of master.

Hauke