[OpenWrt-Devel] [PATCH v6] ath79: add support for COMFAST CF-E130N v2
mail at adrianschmutzler.de
mail at adrianschmutzler.de
Sun May 24 07:45:57 EDT 2020
Hi,
> -----Original Message-----
> From: openwrt-devel [mailto:openwrt-devel-bounces at lists.openwrt.org]
> On Behalf Of admin at kryma.net
> Sent: Freitag, 27. März 2020 04:33
> To: openwrt-devel at lists.openwrt.org
> Cc: Pavel Balan <admin at kryma.net>
> Subject: [OpenWrt-Devel] [PATCH v6] ath79: add support for COMFAST CF-
> E130N v2
>
> From: Pavel Balan <admin at kryma.net>
>
> This patch adds support for the COMFAST CF-E130N v2, an outdoor wireless
> CPE with a single Ethernet port and a 802.11bgn radio.
>
> Specifications:
>
> - QCA9531 SoC
> - 1x 10/100 Mbps Ethernet with PoE-in support
> - 64 MB of RAM (DDR2)
> - 16 MB of FLASH
> - 5 dBi built-in antenna
> - POWER/LAN/WLAN green LEDs
> - 4x RSSI LEDs (2x red, 2x green)
> - UART (115200 8N1) and GPIO (J9) headers on PCB
>
> Flashing instructions:
>
> The original firmware is based on OpenWrt so a sysupgrade image can be
> installed via the stock web GUI.
>
> The U-boot bootloader also contains a backup TFTP client to upload the
> firmware from. Upon boot, it checks its ethernet network for the IP
> 192.168.1.10. Host a TFTP server and provide the image to be flashed as file
> firmware_auto.bin.
>
> Signed-off-by: Pavel Balan <admin at kryma.net>
> ---
> Run-tested on hardware.
>
> Changes since v5:
>
> Made partition at 7e0000 read-only.
>
> Changed IMAGE_SIZE to 7936k.
it looks like you have actually sent the v5 version of your patch again, as the v6-changes you report are not included. Anyway, I've added these (and a few others) myself and pushed the result to my staging tree here:
https://git.openwrt.org/?p=openwrt/staging/adrian.git;a=shortlog;h=refs/heads/staging
Please run this on your device and check whether everything is okay, so I can merge this.
Despite, I'd be interested whether the MAC address from calibration data (art 0x1002) is actually the same as art 0x0, so we can drop mtd-mac-address from wmac.
Best
Adrian
>
> ---
> .../ath79/dts/qca9531_comfast_cf-e130n-v2.dts | 150
> ++++++++++++++++++
> .../generic/base-files/etc/board.d/01_leds | 8 +
> .../generic/base-files/etc/board.d/02_network | 1 +
> target/linux/ath79/image/generic.mk | 10 ++
> 4 files changed, 169 insertions(+)
> create mode 100644 target/linux/ath79/dts/qca9531_comfast_cf-e130n-
> v2.dts
>
> diff --git a/target/linux/ath79/dts/qca9531_comfast_cf-e130n-v2.dts
> b/target/linux/ath79/dts/qca9531_comfast_cf-e130n-v2.dts
> new file mode 100644
> index 0000000000..dc1e037307
> --- /dev/null
> +++ b/target/linux/ath79/dts/qca9531_comfast_cf-e130n-v2.dts
> @@ -0,0 +1,150 @@
> +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT /dts-v1/;
> +
> +#include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/input/input.h>
> +
> +#include "qca953x.dtsi"
> +
> +/ {
> + compatible = "comfast,cf-e130n-v2", "qca,qca9531";
> + model = "COMFAST CF-E130N v2";
> +
> + aliases {
> + serial0 = &uart;
> + led-boot = &led_rssihigh;
> + led-failsafe = &led_rssihigh;
> + led-upgrade = &led_rssihigh;
> + label-mac-device = ð1;
> + };
> +
> + leds {
> + compatible = "gpio-leds";
> +
> + pinctrl-names = "default";
> +
> + wlan {
> + label = "cf-e130n-v2:green:wlan";
> + gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
> + linux,default-trigger = "phy0tpt";
> + };
> +
> + lan {
> + label = "cf-e130n-v2:green:lan";
> + gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
> + };
> +
> + unused {
> + label = "cf-e130n-v2:green:unused";
> + gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
> + };
> +
> + rssilow {
> + label = "cf-e130n-v2:red:rssilow";
> + gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
> + };
> +
> + rssimediumlow {
> + label = "cf-e130n-v2:red:rssimediumlow";
> + gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
> + };
> +
> + rssimediumhigh {
> + label = "cf-e130n-v2:green:rssimediumhigh";
> + gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
> + };
> +
> + led_rssihigh: rssihigh {
> + label = "cf-e130n-v2:green:rssihigh";
> + gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
> + };
> + };
> +
> + keys {
> + compatible = "gpio-keys";
> +
> + reset {
> + label = "reset";
> + linux,code = <KEY_RESTART>;
> + gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
> + debounce-interval = <60>;
> + };
> + };
> +};
> +
> +&spi {
> + status = "okay";
> +
> + num-cs = <1>;
> +
> + flash at 0 {
> + compatible = "jedec,spi-nor";
> + reg = <0>;
> + spi-max-frequency = <25000000>;
> +
> + partitions {
> + compatible = "fixed-partitions";
> + #address-cells = <1>;
> + #size-cells = <1>;
> +
> + partition at 0 {
> + label = "u-boot";
> + reg = <0x000000 0x010000>;
> + read-only;
> + };
> +
> + art: partition at 10000 {
> + label = "art";
> + reg = <0x010000 0x010000>;
> + read-only;
> + };
> +
> + partition at 20000 {
> + compatible = "denx,uimage";
> + label = "firmware";
> + reg = <0x020000 0x7c0000>;
> + };
> +
> + partition at 7e0000 {
> + compatible = "denx,uimage";
> + label = "configs";
> + reg = <0x7e0000 0x010000>;
> + };
> +
> + partition at 7f0000 {
> + label = "nvram";
> + reg = <0x7f0000 0x010000>;
> + read-only;
> + };
> + };
> + };
> +};
> +
> +&uart {
> + status = "okay";
> +
> +};
> +
> +ð0 {
> + compatible = "syscon", "simple-mfd";
> +};
> +
> +ð1 {
> + status = "okay";
> +
> + phy-handle = <&swphy0>;
> +
> + mtd-mac-address = <&art 0x0>;
> +
> + gmac-config {
> + device = <&gmac>;
> + switch-phy-swap = <1>;
> + };
> +};
> +
> +&wmac {
> + status = "okay";
> +
> + mtd-mac-address = <&art 0x0>;
> + mtd-cal-data = <&art 0x1000>;
> +};
> diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds
> b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
> index fbb0d0ea03..3046d34605 100755
> --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds
> +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
> @@ -47,6 +47,14 @@ comfast,cf-e120a-v3)
> ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH"
> "$boardname:green:rssimediumhigh" "wlan0" "51" "100"
> ucidef_set_led_rssi "rssihigh" "RSSIHIGH"
> "$boardname:green:rssihigh" "wlan0" "76" "100"
> ;;
> +comfast,cf-e130n-v2)
> + ucidef_set_led_netdev "lan" "LAN" "$boardname:green:lan" "eth0"
> + ucidef_set_rssimon "wlan0" "200000" "1"
> + ucidef_set_led_rssi "rssilow" "RSSILOW" "$boardname:red:rssilow"
> "wlan0" "1" "100"
> + ucidef_set_led_rssi "rssimediumlow" "RSSIMEDIUMLOW"
> "$boardname:red:rssimediumlow" "wlan0" "26" "100"
> + ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH"
> "$boardname:green:rssimediumhigh" "wlan0" "51" "100"
> + ucidef_set_led_rssi "rssihigh" "RSSIHIGH"
> "$boardname:green:rssihigh" "wlan0" "76" "100"
> + ;;
> comfast,cf-e313ac)
> ucidef_set_led_switch "lan" "LAN" "$boardname:green:lan"
> "switch0" "0x02"
> ucidef_set_led_netdev "wan" "WAN" "$boardname:green:wan"
> "eth1"
> diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network
> b/target/linux/ath79/generic/base-files/etc/board.d/02_network
> index 10ca213e70..b1ecc066fd 100755
> --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
> +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
> @@ -14,6 +14,7 @@ ath79_setup_interfaces()
> alfa-network,ap121f|\
> aruba,ap-105|\
> avm,fritz300e|\
> + comfast,cf-e130n-v2|\
> devolo,dvl1200i|\
> devolo,dvl1750c|\
> devolo,dvl1750i|\
> diff --git a/target/linux/ath79/image/generic.mk
> b/target/linux/ath79/image/generic.mk
> index 70631c20d0..256481ece3 100644
> --- a/target/linux/ath79/image/generic.mk
> +++ b/target/linux/ath79/image/generic.mk
> @@ -258,6 +258,16 @@ define Device/comfast_cf-e120a-v3 endef
> TARGET_DEVICES += comfast_cf-e120a-v3
>
> +define Device/comfast_cf-e130n-v2
> + ATH_SOC := qca9531
> + DEVICE_VENDOR := COMFAST
> + DEVICE_MODEL := CF-E130N
> + DEVICE_VARIANT := v2
> + DEVICE_PACKAGES := rssileds kmod-leds-gpio -swconfig -uboot-envtools
> + IMAGE_SIZE := 8000k
> +endef
> +TARGET_DEVICES += comfast_cf-e130n-v2
> +
> define Device/comfast_cf-e313ac
> ATH_SOC := qca9531
> DEVICE_VENDOR := COMFAST
> --
> 2.17.1
>
>
> _______________________________________________
> openwrt-devel mailing list
> openwrt-devel at lists.openwrt.org
> https://lists.openwrt.org/mailman/listinfo/openwrt-devel
-------------- next part --------------
A non-text attachment was scrubbed...
Name: openpgp-digital-signature.asc
Type: application/pgp-signature
Size: 834 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/openwrt-devel/attachments/20200524/c32d404d/attachment.sig>
-------------- next part --------------
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
More information about the openwrt-devel
mailing list