[RFC PATCH v2 1/6] ath79: ensure QCA956x gmac0 mux selects sgmii

David Bauer mail at david-bauer.net
Wed Jul 22 06:28:22 EDT 2020


Hi Sander,

this looks good, however there are two minor improvements still open.

On 7/19/20 11:24 PM, Sander Vanheule wrote:
> Some bootloaders do not set up gmac0 properly, leaving it disconnected
> from the sgmii interface. If the user specificies phy-mode sgmii, then
> use the gmac-config/device node to ensure the mux is configured
> correctly.
> 
> Signed-off-by: Sander Vanheule <sander at svanheule.net>
> Cc: David Bauer <mail at david-bauer.net>
> ---
>   .../net/ethernet/atheros/ag71xx/ag71xx_main.c | 38 +++++++++++++++++++
>   1 file changed, 38 insertions(+)
> 
> diff --git a/target/linux/ath79/files/drivers/net/ethernet/atheros/ag71xx/ag71xx_main.c b/target/linux/ath79/files/drivers/net/ethernet/atheros/ag71xx/ag71xx_main.c
> index d611007a86..e86dbfffcf 100644
> --- a/target/linux/ath79/files/drivers/net/ethernet/atheros/ag71xx/ag71xx_main.c
> +++ b/target/linux/ath79/files/drivers/net/ethernet/atheros/ag71xx/ag71xx_main.c
> @@ -665,6 +665,40 @@ out:
>   	of_node_put(np);
>   }
>   
> +static void ag71xx_mux_select_sgmii_qca956x(struct device_node *np)
> +{
> +	struct device_node *np_dev;
> +	void __iomem *gmac_base;
> +	int err = 0;

Remove this, as it is only assigned but never accessed.

> +	u32 serdes_cal;

This is never used.

I'll test this patch on my QCA9563 and QCA9561 devices and report back.

Best wishes
David

> +	u32 t;
> +
> +	np = of_get_child_by_name(np, "gmac-config");
> +	if (!np)
> +		return;
> +
> +	np_dev = of_parse_phandle(np, "device", 0);
> +	if (!np_dev)
> +		goto out;
> +
> +	gmac_base = of_iomap(np_dev, 0);
> +	if (!gmac_base) {
> +		pr_err("%pOF: can't map GMAC registers\n", np_dev);
> +		err = -ENOMEM;
> +		goto err_iomap;
> +	}
> +
> +	t = __raw_readl(gmac_base + QCA956X_GMAC_REG_ETH_CFG);
> +	t |= QCA956X_ETH_CFG_GE0_SGMII;
> +	__raw_writel(t, gmac_base + QCA956X_GMAC_REG_ETH_CFG);
> +
> +	iounmap(gmac_base);
> +err_iomap:
> +	of_node_put(np_dev);
> +out:
> +	of_node_put(np);
> +}
> +
>   static void ath79_mii_ctrl_set_if(struct ag71xx *ag, unsigned int mii_if)
>   {
>   	u32 t;
> @@ -1566,6 +1600,10 @@ static int ag71xx_probe(struct platform_device *pdev)
>   		return ag->phy_if_mode;
>   	}
>   
> +	if (of_device_is_compatible(np, "qca,qca9560-eth") &&
> +	    ag->phy_if_mode == PHY_INTERFACE_MODE_SGMII)
> +		ag71xx_mux_select_sgmii_qca956x(np);
> +
>   	if (of_property_read_u32(np, "qca,mac-idx", &ag->mac_idx))
>   		ag->mac_idx = -1;
>   	if (ag->mii_base)
> 



More information about the openwrt-devel mailing list