[PATCH v2 1/2] ath79: add support for AirTight C-75
Tomasz Maciej Nowak
tmn505 at gmail.com
Tue Dec 15 12:17:08 EST 2020
AirTight Networks (later renamed to Mojo Networks) C-75 is a dual-band
access point, also sold by WatchGuard under name AP320.
Specification
SoC: Qualcomm Atheros QCA9550
RAM: 128 MiB DDR2
Flash: 2x 16 MiB SPI NOR
WIFI: 2.4 GHz 3T3R integrated
5 GHz 3T3R QCA9890 oversized Mini PCIe card
Ethernet: 2x 10/100/1000 Mbps QCA8334
port labeled LAN1 is PoE capable (802.3at)
USB: 1x 2.0
LEDs: 7x which two are GPIO controlled, four switch controlled, one
controlled by wireless driver
Buttons: 1x GPIO controlled
Serial: RJ-45 port, Cisco pinout
baud: 115200, parity: none, flow control: none
JTAG: Yes, pins marked J1 on PCB
Installation
1. Prepare TFTP server with OpenWrt initramfs-kernel image.
2. Connect to one of LAN ports.
3. Connect to serial port.
4. Power on the device and when prompted to stop autoboot, hit any key.
5. Adjust "ipaddr" and "serverip" addresses in U-Boot environment, use
'setenv' to do that, then run following commands:
tftpboot 0x81000000 <openwrt_initramfs-kernel_image_name>
bootm 0x81000000
6. Wait about 1 minute for OpenWrt to boot.
7. Transfer OpenWrt sysupgrade image to /tmp directory and flash it
with:
sysupgrade -n /tmp/<openwrt_sysupgrade_image_name>
8. After flashing, the access point will reboot to OpenWrt. Wait few
minutes, until the Power LED stops blinking, then it's ready for
configuration.
Known issues
Green power LED does not work.
Additional information
The U-Boot fails to initialise ethernet ports correctly when a UART
adapter is attached to UART pins (marked J3 on PCB).
Cc: Vladimir Georgievsky <vladimir.georgievsky at yahoo.com>
Signed-of-by: Tomasz Maciej Nowak <tmn505 at gmail.com>
---
v1 -> v2
- rename primary device vendor (Mojo -> AirTight)
- remove U-Boot environment definition
- minor dts adjustments (no functional changes)
- add additional DEVICE_ALTn variable
.../linux/ath79/dts/qca9550_airtight_c-75.dts | 171 ++++++++++++++++++
.../generic/base-files/etc/board.d/02_network | 4 +
target/linux/ath79/image/generic.mk | 13 ++
3 files changed, 188 insertions(+)
create mode 100644 target/linux/ath79/dts/qca9550_airtight_c-75.dts
diff --git a/target/linux/ath79/dts/qca9550_airtight_c-75.dts b/target/linux/ath79/dts/qca9550_airtight_c-75.dts
new file mode 100644
index 000000000000..34d4c32b3562
--- /dev/null
+++ b/target/linux/ath79/dts/qca9550_airtight_c-75.dts
@@ -0,0 +1,171 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qca955x.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+ model = "AirTight Networks C-75";
+ compatible = "airtight,c-75", "qca,qca9550", "qca,qca9558";
+
+ aliases {
+ label-mac-device = ð0;
+ led-boot = &led_power;
+ led-failsafe = &led_power;
+ led-upgrade = &led_power;
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_power: power {
+ label = "amber:power";
+ gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
+ default-state = "on";
+ };
+
+ wlan2g {
+ label = "green:wlan2g";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy1tpt";
+ };
+ };
+};
+
+ð0 {
+ status = "okay";
+
+ mtd-mac-address = <&art 0x0>;
+ phy-handle = <&phy0>;
+ phy-mode = "rgmii";
+ pll-data = <0xa6000000 0x00000101 0x00001616>;
+};
+
+&mdio0 {
+ status = "okay";
+
+ phy0: ethernet-phy at 0 {
+ reg = <0>;
+ qca,ar8327-initvals = <
+ 0x0c 0x00080080
+ 0x04 0x07600000
+ 0x58 0xc935c935
+ 0x5c 0x03ffff00
+ 0x7c 0x0000007e
+ 0x94 0x0000007e
+ >;
+ };
+};
+
+ð1 {
+ status = "okay";
+
+ mtd-mac-address = <&art 0x6>;
+ phy-mode = "sgmii";
+ pll-data = <0x03000101 0x00000101 0x00001616>;
+
+ fixed-link {
+ speed = <1000>;
+ full-duplex;
+ };
+};
+
+&pcie0 {
+ status = "okay";
+
+ wifi at 0,0 {
+ compatible = "qcom,ath10k";
+ reg = <0x0000 0 0 0 0>;
+ };
+};
+
+&spi {
+ status = "okay";
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x000000 0x040000>;
+ read-only;
+ };
+
+ partition at 40000 {
+ label = "u-boot-env";
+ reg = <0x040000 0x010000>;
+ };
+
+ partition at 50000 {
+ label = "wlandrv";
+ reg = <0x050000 0x010000>;
+ read-only;
+ };
+
+ partition at 60000 {
+ label = "firmware";
+ reg = <0x060000 0xf90000>;
+ compatible = "denx,uimage";
+ };
+
+ art: partition at ff0000 {
+ label = "art";
+ reg = <0xff0000 0x010000>;
+ read-only;
+ };
+ };
+ };
+
+ flash at 1 {
+ compatible = "jedec,spi-nor";
+ reg = <1>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "opt";
+ reg = <0x0 0x1000000>;
+ };
+ };
+ };
+};
+
+&uart {
+ status = "okay";
+};
+
+&usb_phy0 {
+ status = "okay";
+};
+
+&usb0 {
+ status = "okay";
+};
+
+&wmac {
+ status = "okay";
+
+ mtd-cal-data = <&art 0x1000>;
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index 905848a2badc..866d74fae435 100755
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -81,6 +81,10 @@ ath79_setup_interfaces()
winchannel,wb2000)
ucidef_set_interface_lan "eth0"
;;
+ airtight,c-75)
+ ucidef_add_switch "switch0" \
+ "0 at eth0" "2:wan" "3:lan" "6 at eth1"
+ ;;
alfa-network,ap121fe)
ucidef_set_interface_lan "eth0 usb0"
;;
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index b3fca9eb8f7f..177caafa2253 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -237,6 +237,19 @@ define Device/adtran_bsap1840
endef
TARGET_DEVICES += adtran_bsap1840
+define Device/airtight_c-75
+ SOC := qca9550
+ DEVICE_VENDOR := AirTight Networks
+ DEVICE_MODEL := C-75
+ DEVICE_ALT0_VENDOR := Mojo Networks
+ DEVICE_ALT0_MODEL := C-75
+ DEVICE_ALT1_VENDOR := WatchGuard
+ DEVICE_ALT1_MODEL := AP320
+ DEVICE_PACKAGES := ath10k-firmware-qca988x kmod-ath10k-ct kmod-usb2
+ IMAGE_SIZE := 15936k
+endef
+TARGET_DEVICES += airtight_c-75
+
define Device/alfa-network_ap121f
SOC := ar9331
DEVICE_VENDOR := ALFA Network
--
2.29.2
More information about the openwrt-devel
mailing list