[PATCH] ath79: add support for TP-Link TL-WR710N v2.1
Adrian Schmutzler
freifunk at adrianschmutzler.de
Tue Aug 18 10:45:57 EDT 2020
This adds support for the TP-Link TL-WR710N v2.1. It is basically a
re-issue of the v1.2.
Specifications:
SoC: Atheros AR9331
CPU: 400 MHz
Flash: 8 MiB
RAM: 32 MiB
WiFi: 2.4 GHz b/g/n
Ethernet: 2x 100M ports
USB: 1x 2.0
The only difference from the v1 is the TP-Link hardware ID/revision.
Attention:
The TL-WR710N v2.0 (!) has only 4 MB flash and cannot be flashed with
this image. It has a different TPLINK_HWREV, so accidental flashing
of the factory image should be impossible without additional measures.
Unfortunately, the v2.0 in ar71xx has the same board name, so sysupgrade
from ar71xx v2.0 into ath79 v1/v2.1 will not be prevented, but will brick
the device.
Flashing instruction:
Upload the factory image via the OEM firmware GUI upgrade mechanism.
Further notes:
To make implementation easier if somebody desires to port the 4M v2.0,
this already creates two DTSI files.
Signed-off-by: Adrian Schmutzler <freifunk at adrianschmutzler.de>
Tested-by: Fabian Eppig <fabian at eppig.de>
---
.../ath79/dts/ar9331_tplink_tl-wr710n-8m.dtsi | 39 ++++++
.../ath79/dts/ar9331_tplink_tl-wr710n-v1.dts | 118 +-----------------
.../dts/ar9331_tplink_tl-wr710n-v2.1.dts | 9 ++
.../ath79/dts/ar9331_tplink_tl-wr710n.dtsi | 88 +++++++++++++
target/linux/ath79/image/generic-tp-link.mk | 12 ++
5 files changed, 149 insertions(+), 117 deletions(-)
create mode 100644 target/linux/ath79/dts/ar9331_tplink_tl-wr710n-8m.dtsi
create mode 100644 target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v2.1.dts
create mode 100644 target/linux/ath79/dts/ar9331_tplink_tl-wr710n.dtsi
diff --git a/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-8m.dtsi b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-8m.dtsi
new file mode 100644
index 0000000000..ffc98e6e1c
--- /dev/null
+++ b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-8m.dtsi
@@ -0,0 +1,39 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "ar9331_tplink_tl-wr710n.dtsi"
+
+&spi {
+ status = "okay";
+
+ num-cs = <1>;
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ uboot: partition at 0 {
+ reg = <0x0 0x20000>;
+ label = "u-boot";
+ read-only;
+ };
+
+ partition at 20000 {
+ compatible = "tplink,firmware";
+ reg = <0x20000 0x7d0000>;
+ label = "firmware";
+ };
+
+ art: partition at 7f0000 {
+ reg = <0x7f0000 0x10000>;
+ label = "art";
+ read-only;
+ };
+ };
+ };
+};
diff --git a/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v1.dts b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v1.dts
index 493dbfe7b6..634b56d3be 100644
--- a/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v1.dts
+++ b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v1.dts
@@ -1,125 +1,9 @@
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
-#include <dt-bindings/gpio/gpio.h>
-#include <dt-bindings/input/input.h>
-
-#include "ar9331.dtsi"
+#include "ar9331_tplink_tl-wr710n-8m.dtsi"
/ {
model = "TP-Link TL-WR710N v1";
compatible = "tplink,tl-wr710n-v1", "qca,ar9331";
-
- aliases {
- serial0 = &uart;
- led-boot = &led_system;
- led-failsafe = &led_system;
- led-running = &led_system;
- led-upgrade = &led_system;
- label-mac-device = ð0;
- };
-
- keys {
- compatible = "gpio-keys";
-
- reset {
- label = "reset";
- linux,code = <KEY_RESTART>;
- gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
- debounce-interval = <60>;
- };
- };
-
- leds {
- compatible = "gpio-leds";
-
- led_system: system {
- label = "tl-wr710n:green:system";
- gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
- };
- };
-
- reg_usb_vbus: regulator {
- compatible = "regulator-fixed";
- regulator-name = "usb_vbus";
- regulator-min-microvolt = <5000000>;
- regulator-max-microvolt = <5000000>;
- gpio = <&gpio 8 GPIO_ACTIVE_HIGH>;
- enable-active-high;
- };
-};
-
-&spi {
- status = "okay";
- num-cs = <1>;
-
- flash at 0 {
- compatible = "jedec,spi-nor";
- reg = <0>;
- spi-max-frequency = <25000000>;
-
- partitions {
- compatible = "fixed-partitions";
- #address-cells = <1>;
- #size-cells = <1>;
-
- uboot: partition at 0 {
- reg = <0x0 0x20000>;
- label = "u-boot";
- read-only;
- };
-
- firmware: partition at 20000 {
- compatible = "tplink,firmware";
- reg = <0x20000 0x7d0000>;
- label = "firmware";
- };
-
- art: partition at 7f0000 {
- reg = <0x7f0000 0x10000>;
- label = "art";
- read-only;
- };
- };
- };
-};
-
-ð0 {
- status = "okay";
-
- mtd-mac-address = <&uboot 0x1fc00>;
-
- gmac-config {
- device = <&gmac>;
-
- switch-phy-addr-swap = <0>;
- switch-phy-swap = <0>;
- };
-};
-
-ð1 {
- status = "okay";
-
- mtd-mac-address = <&uboot 0x1fc00>;
- mtd-mac-address-increment = <(-1)>;
-};
-
-&uart {
- status = "okay";
-};
-
-&usb {
- dr_mode = "host";
- vbus-supply = <®_usb_vbus>;
- status = "okay";
-};
-
-&usb_phy {
- status = "okay";
-};
-
-&wmac {
- status = "okay";
- mtd-cal-data = <&art 0x1000>;
- mtd-mac-address = <&uboot 0x1fc00>;
};
diff --git a/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v2.1.dts b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v2.1.dts
new file mode 100644
index 0000000000..48d44000ee
--- /dev/null
+++ b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n-v2.1.dts
@@ -0,0 +1,9 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar9331_tplink_tl-wr710n-8m.dtsi"
+
+/ {
+ model = "TP-Link TL-WR710N v2.1";
+ compatible = "tplink,tl-wr710n-v2.1", "qca,ar9331";
+};
diff --git a/target/linux/ath79/dts/ar9331_tplink_tl-wr710n.dtsi b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n.dtsi
new file mode 100644
index 0000000000..e37c43f4a7
--- /dev/null
+++ b/target/linux/ath79/dts/ar9331_tplink_tl-wr710n.dtsi
@@ -0,0 +1,88 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "ar9331.dtsi"
+
+/ {
+ aliases {
+ serial0 = &uart;
+ led-boot = &led_system;
+ led-failsafe = &led_system;
+ led-running = &led_system;
+ led-upgrade = &led_system;
+ label-mac-device = ð0;
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+ debounce-interval = <60>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_system: system {
+ label = "tl-wr710n:green:system";
+ gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ reg_usb_vbus: regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "usb_vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&gpio 8 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+};
+
+ð0 {
+ status = "okay";
+
+ mtd-mac-address = <&uboot 0x1fc00>;
+
+ gmac-config {
+ device = <&gmac>;
+
+ switch-phy-addr-swap = <0>;
+ switch-phy-swap = <0>;
+ };
+};
+
+ð1 {
+ status = "okay";
+
+ mtd-mac-address = <&uboot 0x1fc00>;
+ mtd-mac-address-increment = <(-1)>;
+};
+
+&uart {
+ status = "okay";
+};
+
+&usb {
+ status = "okay";
+
+ dr_mode = "host";
+ vbus-supply = <®_usb_vbus>;
+};
+
+&usb_phy {
+ status = "okay";
+};
+
+&wmac {
+ status = "okay";
+
+ mtd-cal-data = <&art 0x1000>;
+ mtd-mac-address = <&uboot 0x1fc00>;
+};
diff --git a/target/linux/ath79/image/generic-tp-link.mk b/target/linux/ath79/image/generic-tp-link.mk
index fdc94b738a..7128d853f8 100644
--- a/target/linux/ath79/image/generic-tp-link.mk
+++ b/target/linux/ath79/image/generic-tp-link.mk
@@ -625,6 +625,18 @@ define Device/tplink_tl-wr710n-v1
endef
TARGET_DEVICES += tplink_tl-wr710n-v1
+define Device/tplink_tl-wr710n-v2.1
+ $(Device/tplink-8mlzma)
+ SOC := ar9331
+ DEVICE_MODEL := TL-WR710N
+ DEVICE_VARIANT := v2.1
+ DEVICE_PACKAGES := kmod-usb-chipidea2 kmod-usb-ledtrig-usbport
+ TPLINK_HWID := 0x07100002
+ TPLINK_HWREV := 0x2
+ SUPPORTED_DEVICES += tl-wr710n
+endef
+TARGET_DEVICES += tplink_tl-wr710n-v2.1
+
define Device/tplink_tl-wr810n-v1
$(Device/tplink-8mlzma)
SOC := qca9531
--
2.20.1
More information about the openwrt-devel
mailing list