[OpenWrt-Devel] [PATCH v2 6/7] lantiq: set checksum when patching MAC address on ath10k

[Adrian Schmutzler]

One lantiq device uses ath10kcal_patch_mac, although all ath10k
eeproms have a checksum field and should use
ath10kcal_patch_mac_crc.
This might be because the field is not evaluated by the firmware at
the moment.

Nevertheless, this patch will use ath10kcal_patch_mac_crc for all
devices so the correct checksum is in place.

Signed-off-by: Adrian Schmutzler <freifunk at adrianschmutzler.de>

---

v2: New patch
---
 .../lantiq/base-files/etc/hotplug.d/firmware/11-ath10k-caldata  | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/target/linux/lantiq/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/lantiq/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index 244635c6db..dbfd201193 100644
--- a/target/linux/lantiq/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/lantiq/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -11,7 +11,7 @@ case "$FIRMWARE" in
 	case $board in
 		bt,homehub-v5a)
 			caldata_extract_ubi "caldata" 0x5000 0x844
-			ath10kcal_patch_mac $(macaddr_add $(mtd_get_mac_binary_ubi caldata 0x110c) +3)
+			ath10kcal_patch_mac_crc $(macaddr_add $(mtd_get_mac_binary_ubi caldata 0x110c) +3)
 			;;
 		*)
 			caldata_die "board $board is not supported yet"
-- 
2.20.1


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel