[OpenWrt-Devel] [PATCH] ar71xx: enable QCA955x SGMII fixup on Mikrotik wAP AC

Etienne Champetier champetier.etienne at gmail.com
Sat Jul 13 22:43:28 EDT 2019


fixes intermittent loss of connectivity on 1Gbit port, with log message:
> 803x_aneg_done: SGMII link is not ok

Thanks to David Bauer for pointing me in the right direction
I just had to figure out the right bus_id, which you find in this log:
> ag71xx ag71xx.1: connected to PHY at gpio-1:00 [uid=004dd074, driver=Atheros 8031 ethernet]

Fixes FS#2236

Signed-off-by: Etienne Champetier <champetier.etienne at gmail.com>
---
 .../ar71xx/files/arch/mips/ath79/mach-rbspi.c    | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/target/linux/ar71xx/files/arch/mips/ath79/mach-rbspi.c b/target/linux/ar71xx/files/arch/mips/ath79/mach-rbspi.c
index 96511a4080..1212a91d7e 100644
--- a/target/linux/ar71xx/files/arch/mips/ath79/mach-rbspi.c
+++ b/target/linux/ar71xx/files/arch/mips/ath79/mach-rbspi.c
@@ -512,6 +512,18 @@ static struct platform_device rbwapgsc_phy_device = {
 	},
 };
 
+static struct at803x_platform_data rbwapgsc_at803x_data = {
+    .override_sgmii_aneg = 1,
+};
+
+static struct mdio_board_info rbwapgsc_mdio_info[] = {
+    {
+        .bus_id = "gpio-1",
+        .mdio_addr = RBWAPGSC_MDIO_PHYADDR,
+        .platform_data = &rbwapgsc_at803x_data,
+    },
+};
+
 /* RB911L GPIOs */
 #define RB911L_GPIO_BTN_RESET	15
 #define RB911L_GPIO_LED_1	13
@@ -1106,10 +1118,14 @@ static void __init rbwapgsc_setup(void)
 
 	platform_device_register(&rbwapgsc_phy_device);
 
+	mdiobus_register_board_info(rbwapgsc_mdio_info,
+				    ARRAY_SIZE(rbwapgsc_mdio_info));
+
 	ath79_init_mac(ath79_eth1_data.mac_addr, ath79_mac_base, 0);
 	ath79_eth1_data.mii_bus_dev = &rbwapgsc_phy_device.dev;
 	ath79_eth1_data.phy_if_mode = PHY_INTERFACE_MODE_SGMII;
 	ath79_eth1_data.phy_mask = BIT(RBWAPGSC_MDIO_PHYADDR);
+	ath79_eth1_data.enable_sgmii_fixup = 1;
 	ath79_eth1_pll_data.pll_1000 = 0x03000101;
 	ath79_eth1_pll_data.pll_100 = 0x80000101;
 	ath79_eth1_pll_data.pll_10 = 0x80001313;
-- 
2.21.0


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list