[OpenWrt-Devel] [PATCH] config: kernel: Fix missing symbol on brcm2708 with CGROUPS

[cshored at thecshore.com]

From: "Daniel F. Dickinson" <cshored at thecshore.com>

When CGROUP block io is enabled a new symbol is exposed and needs to
be set or unset else kernel oldconfig hangs waiting for input during
normal OpenWrt builds.  Therefore add sane defaults for this symbol
in that case.  Also, the defaults brcm2708 are different than generic
defaults because the platform's defconfig enables BLK_DEV_THROTTLING
by default (in defconfig config from the patches used to match
upstream's kernel, not in OpenWrt config-4.xx).

Signed-off-by: Daniel F. Dickinson <cshored at thecshore.com>
---
 config/Config-kernel.in | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/config/Config-kernel.in b/config/Config-kernel.in
index f38cc792dd..6b571368f2 100644
--- a/config/Config-kernel.in
+++ b/config/Config-kernel.in
@@ -519,6 +519,23 @@ if KERNEL_CGROUPS
 		  CONFIG_CFQ_GROUP_IOSCHED=y; for enabling throttling policy, set
 		  CONFIG_BLK_DEV_THROTTLING=y.
 
+	if KERNEL_BLK_CGROUP
+
+		config KERNEL_CFQ_GROUP_IOSCHED
+			bool "Proportional weight of disk bandwidth in CFQ"
+			default n if KERNEL_BLK_DEV_THROTTLING
+			default y
+
+		config KERNEL_BLK_DEV_THROTTLING
+			bool "Enable throttling policy"
+			default y if TARGET_brcm2708
+			default n
+
+		config KERNEL_BLK_DEV_THROTTLING_LOW
+			bool "Block throttling .low limit interface support (EXPERIMENTAL)"
+			default n
+	endif
+
 	config KERNEL_DEBUG_BLK_CGROUP
 		bool "Enable Block IO controller debugging"
 		default n
-- 
2.11.0


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel