[OpenWrt-Devel] [PATCH 1/2] ath79: add support for devolo WiFi pro 1750i
David Bauer
mail at david-bauer.net
Tue Jan 1 13:17:22 EST 2019
Hardware
--------
CPU: Qualcomm Atheros QCA9558
RAM: 128M DDR2
FLASH: 16MiB
ETH: 1x Atheros AR8035 (PoE in)
WiFi2: QCA9558 3T3R
WiFi5: QCA9880 3T3R
BTN: 1x Reset
LED: 1x LED blue
1x LED red
BEEP: 1x GPIO attached piezo beeper
UART: 3.3V GND TX RX (115200-N-8) (3.3V is square pad)
Header is located next to reset-button
Installation
------------
Make sure you set a password for the root user as prompted on first
setup!
1. Upload OpenWRT sysupgrade image via SSH to the device.
Use /tmp as the destination folder on the device.
User is root, password the one set in the web interface.
2. Install OpenWRT with
> sysupgrade -n -F /tmp/<openwrt-image-name>
Signed-off-by: David Bauer <mail at david-bauer.net>
---
.../ath79/base-files/etc/board.d/02_network | 1 +
.../etc/hotplug.d/firmware/11-ath10k-caldata | 3 +-
.../ath79/dts/qca9558_devolo_dvl1750i.dts | 51 +++++++++++++++++++
target/linux/ath79/image/generic.mk | 8 +++
4 files changed, 62 insertions(+), 1 deletion(-)
create mode 100644 target/linux/ath79/dts/qca9558_devolo_dvl1750i.dts
diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network
index e24c58e208..c5c163c6ec 100755
--- a/target/linux/ath79/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/base-files/etc/board.d/02_network
@@ -11,6 +11,7 @@ ath79_setup_interfaces()
case "$board" in
avm,fritz300e|\
devolo,dvl1750c|\
+ devolo,dvl1750i|\
ocedo,koala|\
ocedo,raccoon|\
pcs,cap324|\
diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index 441893a752..bd26f35f50 100644
--- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -88,7 +88,8 @@ case "$FIRMWARE" in
"ath10k/cal-pci-0000:00:00.0.bin")
case $board in
devolo,dvl1200e|\
- devolo,dvl1750c)
+ devolo,dvl1750c|\
+ devolo,dvl1750i)
ath10kcal_extract "art" 20480 2116
ath10kcal_patch_mac_crc $(macaddr_add $(mtd_get_mac_binary art 0) -1)
;;
diff --git a/target/linux/ath79/dts/qca9558_devolo_dvl1750i.dts b/target/linux/ath79/dts/qca9558_devolo_dvl1750i.dts
new file mode 100644
index 0000000000..bd3702eb36
--- /dev/null
+++ b/target/linux/ath79/dts/qca9558_devolo_dvl1750i.dts
@@ -0,0 +1,51 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca9558_devolo_dvl1xxx.dtsi"
+
+/ {
+ compatible = "devolo,dvl1750i", "qca,qca9557";
+ model = "devolo WiFi pro 1750i";
+
+ aliases {
+ led-boot = &status_blue;
+ led-failsafe = &status_red;
+ led-running = &status_blue;
+ led-upgrade = &status_red;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ status_blue: status_blue {
+ label = "dvl1750i:blue:status";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ default-state = "on";
+ };
+
+ status_red: status_red {
+ label = "dvl1750i:red:status";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ beeper {
+ compatible = "gpio-beeper";
+ gpios = <&gpio 4 GPIO_ACTIVE_HIGH>;
+ };
+};
+
+ð0 {
+ pll-data = <0xbe000000 0x80000101 0x80001313>;
+};
+
+&gmac_config {
+ rxdv-delay = <3>;
+ rxd-delay = <3>;
+ txen-delay = <3>;
+ txd-delay = <3>;
+ rgmii-enabled = <1>;
+};
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index 326633835d..b8c67e1638 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -178,6 +178,14 @@ define Device/devolo_dvl1750c
endef
TARGET_DEVICES += devolo_dvl1750c
+define Device/devolo_dvl1750i
+ ATH_SOC := qca9558
+ DEVICE_TITLE := devolo WiFi pro 1750i
+ DEVICE_PACKAGES := kmod-ath10k-ct ath10k-firmware-qca988x-ct
+ IMAGE_SIZE := 15936k
+endef
+TARGET_DEVICES += devolo_dvl1750i
+
define Device/dlink_dir-825-b1
ATH_SOC := ar7161
DEVICE_TITLE := D-LINK DIR-825 B1
--
2.20.1
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
More information about the openwrt-devel
mailing list