[OpenWrt-Devel] MV88E6060 switch

[Nerijus Baliunas]

On Thu, 27 Jul 2017 21:31:01 +0300 Sergey Ryazanov <ryazanov.s.a at gmail.com> wrote:

> > Tried the latest LEDE. Now I see in the boot log:
> > [    6.507617] NPE-B: firmware's license can be found in 
> > /usr/share/doc/LICENSE.IPL
> > [    6.515168] NPE-B: firmware functionality 0x2, revision 0x2:1
> > [    6.523171] eth0: link up, speed 0 Mb/s, full duplex
> 
> Did  you  see  the  "Marvell  88E6060  PHY  driver attached" in kernel
> messages   log?  If  not then the mwswitch driver did not attached and
> you  should  fix  this  first.  And  only  then  go  to  the interface
> configuration.

No, dmesg|grep 6060 does not show anything. How do I fix it?

> > and now I see RX and TX packets on eth0 (they were 0 before).
> 
> Did you try to use tcpdump to see what RXed by the interface?

No, but I'll try.

Regards,
Nerijus
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel