[OpenWrt-Devel] [PATCH v2] ARM: dts: Add ethernet PHYs to the a bunch of Geminis

[Linus Walleij]

On Sun, Dec 3, 2017 at 5:06 PM, Andrew Lunn <andrew at lunn.ch> wrote:
> On Sun, Dec 03, 2017 at 04:04:57PM +0100, Linus Walleij wrote:
>> These Gemini boards have Ethernet PHY on GPIO bit-banged
>> MDIO, clearly defined in the corresponding OpenWRT
>> ethernet patches since ages. Add them in accordance with
>> the OpenWRT patch so we can use them when we add ethernet
>> support.
>>
>> Cc: Andrew Lunn <andrew at lunn.ch>
>> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
>
> Reviewed-by: Andrew Lunn <andrew at lunn.ch>

Thanks man.

> This is good as is, but i just wonder if the mdio node can be moved
> into the .dtsi file. Four from six have the exact same setup. So i'm
> guessing the reference design has been copied.

Yeah they all have the GPIO lines similarly so far.
I might break out a DTSI with common stuff based on the
reference design. The main DTSI should be the chipset
but we can surely have a gemi-standard-board.dtsi as well.

Yours,
Linus Walleij
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel