[OpenWrt-Devel] Change Uboot default values

[Baptiste Clenet]

2015-07-22 13:54 GMT+02:00 Yousong Zhou <yszhou4tech at gmail.com>:
> On 22 July 2015 at 19:37, Baptiste Clenet <bapclenet at gmail.com> wrote:
>> Hi,
>>
>> I would like to change the default values of Uboot when I choose 2 in the menu.
>> In the below example, I would like to change <1>, <2> and <3> by
>> defaults values that I would have set earlier.
>>
>
> Looks like it's most likely hardcoded [1].
>
>  [1] https://github.com/8devices/u-boot/blob/a4ac3be49389f0801cae4c37454e59679d56f036/lib_mips/board.c#L1502
>

Yeah, but how to change the value then, I don't mind to hardcode them,
it's to flash quicker (not enter each time the values).
I changed it on one board but I don't remember how I have done that.

>
>                 yousong
>
>> Example:
>>
>> Please choose the operation:
>>    1: Load system code to SDRAM via TFTP.
>>    2: Load system code then write to Flash via TFTP.
>>    3: Boot system code via Flash (default).
>>    4: Entr boot command line interface.
>>    7: Load Boot Loader code then write to Flash via Serial.
>>    9: Load Boot Loader code then write to Flash via TFTP.
>>
>> You choosed 2
>>
>> 2: System Load Linux Kernel then write to Flash via TFTP.
>>  Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N)
>>  Please Input new ones /or Ctrl-C to discard
>>         Input device IP (10.10.10.123) ==: <1>
>>         Input server IP (10.10.10.3) ==: <2>
>>         Input Linux Kernel filename () ==:<3>
>>
>> Cheers,
>>
>> --
>> Baptiste
>> _______________________________________________
>> openwrt-devel mailing list
>> openwrt-devel at lists.openwrt.org
>> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel



-- 
Baptiste
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel