[OpenWrt-Devel] ar71xx update to v3.18

[Paul Blazejowski]

On Mon, 2015-02-16 at 08:10 +0100, John Crispin wrote:
> 
> On 16/02/2015 00:15, Paul Blazejowski wrote:
> > 00 KHz AUTO), (N/A, 2000 mBm), (0 s)
> > [   21.730000] cfg80211:   (5490000 KHz - 5730000 KHz @ 160000 KHz),
> > (N/A, 2000 mBm), (0 s)
> > [   21.740000] cfg80211:   (5735000 KHz - 5835000 KHz @ 80000 KHz),
> > (N/A, 2000 mBm), (N/A)
> > [   21.750000] cfg80211:   (57240000 KHz - 63720000 KHz @ 2160000 KHz),
> > (N/A, 0 mBm), (N/A)
> > [   22.170000] ath9k ar934x_wmac: Direct firmware load for
> > soc_wmac.eeprom failed with error -2
> > [   22.180000] ath: phy0: Unable to load EEPROM file soc_wmac.eeprom
> > [   22.190000] ath9k ar934x_wmac: failed to initialize device
> > [   22.190000] ath9k: probe of ar934x_wmac failed with error -22
> > [   22.200000] PCI: Enabling device 0000:00:00.0 (0000 -> 0002)
> > [   22.220000] ath9k 0000:00:00.0: Direct firmware load for
> > pci_wmac0.eeprom failed with error -2
> > [   22.230000] ath: phy1: Unable to load EEPROM file pci_wmac0.eeprom
> > [   22.230000] ath9k 0000:00:00.0: Failed to initialize device
> > [   22.240000] ath9k: probe of 0000:00:00.0 failed with error -22
> > [   29.760000] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
> 
> probably related to this -> https://dev.openwrt.org/ticket/18992
> 
> do a "cat /tmp/sysinfo/*" please

nope sir, just replied to your other mail...but here it is again:

root at router:~# cat /tmp/sysinfo/*
wndr3700v4
NETGEAR WNDR3700v4
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel