[OpenWrt-Devel] [PATCH] [ipq806x] Add initial support for TP-Link Archer C2600

[Jonas Gorski]

Hi,

please try to keep the number of replies low, ideally one.

On Mon, Dec 7, 2015 at 5:05 PM, Josh Bendavid <Josh.Bendavid at cern.ch> wrote:
> (Sorry about the top posting)
>

and keep some context to what you are replying to.

> For the flash, the stock firmware, and the factory images built with these
> patches are using only the NOR flash as far as I know.
>
> I am not 100% sure whether the NAND is physically there or not (what would
> be the easiest way to check?)

check for lines like this:

[    0.965016] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xaa
[    0.966215] nand: Micron MT29F2G08ABBEAH4
[    0.972816] nand: 256MiB, SLC, page size: 2048, OOB size: 64

On Mon, Dec 7, 2015 at 4:57 PM, Josh Bendavid <Josh.Bendavid at cern.ch> wrote:
> For the WAN link, I did not test it myself yet with 10 or 100mbps, but the
> situation should be the same as described here
> https://dev.openwrt.org/changeset/47695/trunk/target/linux/ipq806x

That was intended as a hint that your dts file did not include the fix
mentioned in the commit, in case it is wired up the same.


Jonas
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel