[OpenWrt-Devel] ar934x+ar8327v4

[Chris Green]

On Fri, Dec 05, 2014 at 12:39:16PM -0700, David Hutchison wrote:
> Here is a test I did by setting up swconfig manually. As you can see I
> put ports 1 and 2 into vlangroup 1. Traffic from port 2 can ping
> 10.128.41.1 which is a device on port 1. However eth0.1 which as
> address 10.128.41.249 cannot ping 10.128.41.1 device on port 1.
> Attached is the swconfig setup, and a dmesg.
> 
> Here is the arp result as well:
> root at OpenWrt:/# arp -n
> IP address       HW type     Flags       HW address            Mask     Device
> 10.128.41.1      0x1         0x0         00:00:00:00:00:00     *        eth0.1
> 
> I used to be able to do:
> root at OpenWrt:/# swconfig dev eth0 show
> Failed to connect to the switch
> root at OpenWrt:/# swconfig list
> Found: switch0 - ag71xx-mdio.0
> 
> Do you not think this is an issue with ag71xx? Do you it is something
> in user-space?
> 
Same on mine (except I have an eth1 which is the 10/100 that works
OK):- 

root at OpenWrt:~# swconfig dev eth0 show
Failed to connect to the switch. Use the "list" command to see which switches are available.
root at OpenWrt:~# swconfig list
Found: switch0 - ag71xx-mdio.0
Found: switch1 - eth1
root at OpenWrt:~# 

-- 
Chris Green
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel